DEMON CARBURETION

Carburetor Power Valve - Standard - 6.5" of Mercury to open valve

Proper power valve selection is crucial to carburetor tuning Demon Fuel Systems offers a complete range of quality power valves to accommodate every tuning requirement. Our power valves are rated in...

Carburetor Power Valve - Standard - 7.5" of Mercury to open valve

Proper power valve selection is crucial to carburetor tuning Demon Fuel Systems offers a complete range of quality power valves to accommodate every tuning requirement. Our power valves are rated in...

Carburetor Power Valve Block-Off Plug - Completely blocks all power-valve circuitry

Carburetor Studs - 1.44" Long w/ 5/16"-18 threads on one end and 5/16"-24 on other end

Recommended when installing any carburetor to prevent baseplate warping and stripping the intake manifold. Each kit includes high quality washers and hex nuts.

Carburetor Throttle Stud - Compatible with countless Chrysler applications

Throttle and Cruise Control Stud for Chrysler Applications

Choke Thermostat Gasket - Developed specifically for Street Demon carburetors

Choke thermostat gasket for Street Demon® carburetors.

Chrome Fuel Line

Carburetor Fuel Line - 3/8 in NPT Female Inlet - 9/16-24 in Dual Outlets - 1/8 in Gauge Port - Stainless - Chrome - Demon Carburetors - Kit

Custom Air Bleeds - Complete set of 10 - 10/32" ready to drill

Air bleeds affect carburetor fuel delivery throughout the rpm range. Demon Fuel Systems replacement air bleeds allow you to custom tailor your carburetor's fuel curve. All bleeds feature a .0250"...

Demon Banner - Size: 2' x 6'

Use this awesome Demon carburetion vinyl banner to show your buddies. Features the Demon logo with rip graphics, and is designed with 6 grommets and full four-side stitched hems for strength...

Demon Cap - Demon Cap

Black twill with flat embroidered Demon logo on front, red sandwich bill, & backstrap with woven label of the Demon website.

Demon Dual Feed Bowl Inlet Fitting - -6 AN, 9/16-24, swivel end

The 9/16-24 swivels fit Demon and Claw carburetors. These fittings are part of our forged inlet kits and can be used to connect to fuel logs and othe

Demon Dual Feed Bowl Inlet Fitting - -8 AN, 9/16-24, swivel end

This long stem #8 female swivel fitting fits all Holley dual feed bowls and others with 7/8" -20 threads. The 9/16-24 swivels fit Demon and Claw carburetors. These fittings are part of our forged...